How to Clean Michael Kors Pave Watch Stones and Plating
The short answer to how to clean Michael Kors pave watch stones and bracelets: wipe with a soft dry cloth after wear, lift dust from between the stones with a soft dry brush, and use a barely damp cloth on the metal...

The short answer to how to clean Michael Kors pave watch stones and bracelets: wipe with a soft dry cloth after wear, lift dust from between the stones with a soft dry brush, and use a barely damp cloth on the metal only. Keep the watch away from soaking, ultrasonic cleaners, metal polish and alcohol. Those are the usual causes of loose stones and a thinning finish.
What you are protecting: small stones and a coloured finish
Pavé describes many small stones set close together. On a watch they may sit on the bezel, the dial or the bracelet links, so look at the product photos to see where yours are. Small stones can be held by tiny metal beads, by adhesive, or by both. We do not have that detail for the watches below, so this routine assumes the more fragile case and avoids heat, soaking and solvents.
Gold-tone, rose gold-tone and silver-tone describe the colour of the finish. Abrasion wears a surface layer, and it shows first where metal rubs: the clasp, the underside of the bracelet and the edges of the links.
How to clean Michael Kors pave watch stones and bracelet, step by step
- Wash and dry your hands, then lay the watch on a soft towel. Check that the crown is pushed fully in.
- Wipe the case, dial window and bracelet with a dry microfibre cloth to lift fingerprints and skin oil.
- Brush the stones with a soft, dry, clean brush (a soft makeup brush or a baby toothbrush works). Use light strokes across the surface. Do not dig between stones with a pin or toothpick.
- For dull links, dampen a corner of the cloth with plain water and a drop of mild hand soap, wring it out well, and wipe the metal only. Follow with a corner dampened in clean water.
- Pat everything dry straight away, including between the links and under the clasp. Let it air on the towel before storing.
- Look over the stones under a bright light. A dark gap or a stone that moves means stop and take the watch to a jeweller or watch repairer.
For pavé stones, cleaning is mostly dry work. A dry wipe after each wear does most of it. Save the damp step for when the bracelet looks dull or feels sticky.
Keep these away from the watch:
- Ultrasonic cleaners. Vibration can shake small stones loose.
- Jewellery dips, metal polish, polishing cloths that contain a compound, toothpaste and baking soda. They clean by removing a little surface, which a coloured finish cannot spare.
- Alcohol wipes, hand sanitiser and acetone. Solvents can be hard on adhesive and on finishes.
- Hot water, steam and hair dryers. Heat can soften adhesive.
Water, perfume, sweat and lotion
Our product data for these watches does not include a water rating. Check the product page and the case back before the watch goes near water, and follow that rating. Whatever it says, soapy showers, pools and sea water are worth avoiding, because soap film dulls stones and chlorine and salt are hard on finishes.
Put the watch on last. Perfume, hairspray, sunscreen and lotion should be dry on your skin first, because their residue collects between stones and under links. That film is what makes pavé look cloudy. Let hand sanitiser dry before the bracelet slides back over your wrist.
Sweat leaves salt and moisture in the bracelet. Take the watch off for workouts if you can. If it does get sweaty, wipe it with a cloth dampened in plain water and dry it fully the same day.
Storage and gold-tone watch maintenance
Store the watch on its own, in its box or a soft pouch. The stones can scratch other jewellery, and other jewellery can scratch the finish. Keep it somewhere dry and out of direct sun. A bathroom shelf is a poor place because of steam.
For gold-tone watch maintenance, wear habits matter as much as cleaning. Avoid stacking the watch against metal bangles, which rub the same spot all day. Have links removed by a watch repairer with the right tools, since a slipped tool leaves a scratch that cannot be wiped away. A bracelet that fits properly also slides less, which means less rubbing.
Pavé styles and the care each finish needs
The routine above applies to all of these watches, and the table notes what differs. Prices are as listed at the time of writing, and each is a starting price.
Most Michael Kors watch care is the same across finishes. The leather style is the exception, and it needs a dry wipe for the leather alongside the brush and cloth for the stones and metal.


















